The several days before. I'm looking for information on the Micro Jig Single ZeroPlay Miter Guide Bar, so i would like to describe here.
I am really impressed with this guide bar. I bought 2 of them and plan to buy more in order to make the table saw and band saw sleds (45 degrees cut skids, etc.). I used the 1° Guide bar in a simple cross cut sled. the sled does not wiggle or jiggle at all. I only used a guide bar, with the intention of using the second for greater stability, but that was never a problem, so the second bar will go on a separate jig. BTW-I also recorded the UHMW tape CS Hyde UHMW
The ZeroPlay Guide Bar is a â€�One-Touch Calibration†miter bar (9 ½†in length) that has two stacked half bars with opposing wedges that expand parallel evenly to fit the exact width of a standard miter slot, Shopsmith or even the tricky Generalâ€TMs miter slot. Because the ZeroPlay Guide Bar is a full profile miter that fits the exact width of the miter .... Read more or Check Price
Similar Products
Micro Jig ZP9-B2S2 Zeroplay Guide Bar System Double Pack
Micro Jig ZeroPlay Guide Bar System (2 Bars 2 Stops)
Grizzly G9849 Magnetic Base/Dial Indicator Combo - President's Special
Micro Jig GR-100 GRR-Ripper
POWERTEC 70136 4-Inch to 2-1/2-Inch Cone Reducer
OEMTools 25025 26 Blade Master Feeler Gauge
0 comments:
Post a Comment